Commit 654d2e7c authored by Masanari Iida's avatar Masanari Iida Committed by Jonathan Corbet

doc:pci: Fix typo in Documentation/PCI

This patch fix spelling typo in Documentation/PCI.
Signed-off-by: default avatarMasanari Iida <standby24x7@gmail.com>
Signed-off-by: default avatarJonathan Corbet <corbet@lwn.net>
parent 9ceae1da
......@@ -353,7 +353,7 @@ retry:
rc = pci_enable_msix_range(adapter->pdev, adapter->msix_entries,
maxvec, maxvec);
/*
* -ENOSPC is the only error code allowed to be analized
* -ENOSPC is the only error code allowed to be analyzed
*/
if (rc == -ENOSPC) {
if (maxvec == 1)
......@@ -370,7 +370,7 @@ retry:
return rc;
}
Note how pci_enable_msix_range() return value is analized for a fallback -
Note how pci_enable_msix_range() return value is analyzed for a fallback -
any error code other than -ENOSPC indicates a fatal error and should not
be retried.
......@@ -486,7 +486,7 @@ during development.
If your device supports both MSI-X and MSI capabilities, you should use
the MSI-X facilities in preference to the MSI facilities. As mentioned
above, MSI-X supports any number of interrupts between 1 and 2048.
In constrast, MSI is restricted to a maximum of 32 interrupts (and
In contrast, MSI is restricted to a maximum of 32 interrupts (and
must be a power of two). In addition, the MSI interrupt vectors must
be allocated consecutively, so the system might not be able to allocate
as many vectors for MSI as it could for MSI-X. On some platforms, MSI
......
......@@ -256,7 +256,7 @@ STEP 4: Slot Reset
------------------
In response to a return value of PCI_ERS_RESULT_NEED_RESET, the
the platform will peform a slot reset on the requesting PCI device(s).
the platform will perform a slot reset on the requesting PCI device(s).
The actual steps taken by a platform to perform a slot reset
will be platform-dependent. Upon completion of slot reset, the
platform will call the device slot_reset() callback.
......
......@@ -66,8 +66,8 @@ hardware (mostly chipsets) has root ports that cannot obtain the reporting
source ID. nosourceid=n by default.
2.3 AER error output
When a PCI-E AER error is captured, an error message will be outputed to
console. If it's a correctable error, it is outputed as a warning.
When a PCI-E AER error is captured, an error message will be outputted to
console. If it's a correctable error, it is outputted as a warning.
Otherwise, it is printed as an error. So users could choose different
log level to filter out correctable error messages.
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment