Commit 8cfa26a7 authored by Andy Shevchenko's avatar Andy Shevchenko Committed by Jonathan Cameron

iio: adc: ti-ads7950: Allow to use on ACPI platforms

ACPI enabled platforms do not have a mean of regulators. Instead we use
hard coded voltage value for reference pin. When value is 0 (default) we
fall back to request a regulator.
Signed-off-by: default avatarAndy Shevchenko <andriy.shevchenko@linux.intel.com>
Signed-off-by: default avatarJonathan Cameron <Jonathan.Cameron@huawei.com>
parent 0a60340f
......@@ -21,6 +21,7 @@
* GNU General Public License for more details.
*/
#include <linux/acpi.h>
#include <linux/bitops.h>
#include <linux/device.h>
#include <linux/err.h>
......@@ -37,6 +38,12 @@
#include <linux/iio/trigger_consumer.h>
#include <linux/iio/triggered_buffer.h>
/*
* In case of ACPI, we use the 5000 mV as default for the reference pin.
* Device tree users encode that via the vref-supply regulator.
*/
#define TI_ADS7950_VA_MV_ACPI_DEFAULT 5000
#define TI_ADS7950_CR_MANUAL BIT(12)
#define TI_ADS7950_CR_WRITE BIT(11)
#define TI_ADS7950_CR_CHAN(ch) ((ch) << 7)
......@@ -58,6 +65,7 @@ struct ti_ads7950_state {
struct spi_message scan_single_msg;
struct regulator *reg;
unsigned int vref_mv;
unsigned int settings;
......@@ -305,11 +313,15 @@ static int ti_ads7950_get_range(struct ti_ads7950_state *st)
{
int vref;
vref = regulator_get_voltage(st->reg);
if (vref < 0)
return vref;
if (st->vref_mv) {
vref = st->vref_mv;
} else {
vref = regulator_get_voltage(st->reg);
if (vref < 0)
return vref;
vref /= 1000;
vref /= 1000;
}
if (st->settings & TI_ADS7950_CR_RANGE_5V)
vref *= 2;
......@@ -411,6 +423,10 @@ static int ti_ads7950_probe(struct spi_device *spi)
spi_message_init_with_transfers(&st->scan_single_msg,
st->scan_single_xfer, 3);
/* Use hard coded value for reference voltage in ACPI case */
if (ACPI_COMPANION(&spi->dev))
st->vref_mv = TI_ADS7950_VA_MV_ACPI_DEFAULT;
st->reg = devm_regulator_get(&spi->dev, "vref");
if (IS_ERR(st->reg)) {
dev_err(&spi->dev, "Failed get get regulator \"vref\"\n");
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment