Commit 56f9eac0 authored by Daniel Kurtz's avatar Daniel Kurtz Committed by Daniel Vetter

drm/i915/intel_i2c: use INDEX cycles for i2c read transactions

It is very common for an i2c device to require a small 1 or 2 byte write
followed by a read.  For example, when reading from an i2c EEPROM it is
common to write and address, offset or index followed by a reading some
values.

The i915 gmbus controller provides a special "INDEX" cycle for performing
such a small write followed by a read.  The INDEX can be either one or two
bytes long.  The advantage of using such a cycle is that the CPU has
slightly less work to do once the read with INDEX cycle is started.
Signed-off-by: 's avatarDaniel Kurtz <djkurtz@chromium.org>
Reviewed-by: 's avatarChris Wilson <chris@chris-wilson.co.uk>
Signed-off-by: 's avatarDaniel Vetter <daniel.vetter@ffwll.ch>
parent 72d66afd
......@@ -204,13 +204,15 @@ intel_gpio_setup(struct intel_gmbus *bus, u32 pin)
}
static int
gmbus_xfer_read(struct drm_i915_private *dev_priv, struct i2c_msg *msg)
gmbus_xfer_read(struct drm_i915_private *dev_priv, struct i2c_msg *msg,
u32 gmbus1_index)
{
int reg_offset = dev_priv->gpio_mmio_base;
u16 len = msg->len;
u8 *buf = msg->buf;
I915_WRITE(GMBUS1 + reg_offset,
gmbus1_index |
GMBUS_CYCLE_WAIT |
(len << GMBUS_BYTE_COUNT_SHIFT) |
(msg->addr << GMBUS_SLAVE_ADDR_SHIFT) |
......@@ -276,6 +278,46 @@ gmbus_xfer_write(struct drm_i915_private *dev_priv, struct i2c_msg *msg)
return 0;
}
/*
* The gmbus controller can combine a 1 or 2 byte write with a read that
* immediately follows it by using an "INDEX" cycle.
*/
static bool
gmbus_is_index_read(struct i2c_msg *msgs, int i, int num)
{
return (i + 1 < num &&
!(msgs[i].flags & I2C_M_RD) && msgs[i].len <= 2 &&
(msgs[i + 1].flags & I2C_M_RD));
}
static int
gmbus_xfer_index_read(struct drm_i915_private *dev_priv, struct i2c_msg *msgs)
{
int reg_offset = dev_priv->gpio_mmio_base;
u32 gmbus1_index = 0;
u32 gmbus5 = 0;
int ret;
if (msgs[0].len == 2)
gmbus5 = GMBUS_2BYTE_INDEX_EN |
msgs[0].buf[1] | (msgs[0].buf[0] << 8);
if (msgs[0].len == 1)
gmbus1_index = GMBUS_CYCLE_INDEX |
(msgs[0].buf[0] << GMBUS_SLAVE_INDEX_SHIFT);
/* GMBUS5 holds 16-bit index */
if (gmbus5)
I915_WRITE(GMBUS5 + reg_offset, gmbus5);
ret = gmbus_xfer_read(dev_priv, &msgs[1], gmbus1_index);
/* Clear GMBUS5 after each index transfer */
if (gmbus5)
I915_WRITE(GMBUS5 + reg_offset, 0);
return ret;
}
static int
gmbus_xfer(struct i2c_adapter *adapter,
struct i2c_msg *msgs,
......@@ -300,10 +342,14 @@ gmbus_xfer(struct i2c_adapter *adapter,
I915_WRITE(GMBUS0 + reg_offset, bus->reg0);
for (i = 0; i < num; i++) {
if (msgs[i].flags & I2C_M_RD)
ret = gmbus_xfer_read(dev_priv, &msgs[i]);
else
if (gmbus_is_index_read(msgs, i, num)) {
ret = gmbus_xfer_index_read(dev_priv, &msgs[i]);
i += 1; /* set i to the index of the read xfer */
} else if (msgs[i].flags & I2C_M_RD) {
ret = gmbus_xfer_read(dev_priv, &msgs[i], 0);
} else {
ret = gmbus_xfer_write(dev_priv, &msgs[i]);
}
if (ret == -ETIMEDOUT)
goto timeout;
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment