Commit b3c49c05 authored by Srinidhi KASAGAR's avatar Srinidhi KASAGAR Committed by Linus Torvalds

drivers/leds/leds-lp5521.c: check if reset is successful

Make sure that the reset is successful by issuing a dummy read to R
channel current register and check its default value.  On some platforms,
without this dummy read, any further access to {R/G/B}_EXEC will not have
any impact.

[akpm@linux-foundation.org: fix up code comment]
Signed-off-by: default avatarsrinidhi kasagar <srinidhi.kasagar@stericsson.com>
Tested-by: default avatarNaga Radhesh <naga.radheshy@stericsson.com>
Acked-by: default avatarLinus Walleij <linus.walleij@linaro.org>
Cc: Richard Purdie <richard.purdie@linuxfoundation.org>
Signed-off-by: default avatarAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: default avatarLinus Torvalds <torvalds@linux-foundation.org>
parent 488bc35b
......@@ -97,6 +97,9 @@
/* Status */
#define LP5521_EXT_CLK_USED 0x08
/* default R channel current register value */
#define LP5521_REG_R_CURR_DEFAULT 0xAF
struct lp5521_engine {
int id;
u8 mode;
......@@ -643,6 +646,7 @@ static int __devinit lp5521_probe(struct i2c_client *client,
struct lp5521_chip *chip;
struct lp5521_platform_data *pdata;
int ret, i, led;
u8 buf;
chip = kzalloc(sizeof(*chip), GFP_KERNEL);
if (!chip)
......@@ -681,6 +685,20 @@ static int __devinit lp5521_probe(struct i2c_client *client,
* Exact value is not available. 10 - 20ms
* appears to be enough for reset.
*/
/*
* Make sure that the chip is reset by reading back the r channel
* current reg. This is dummy read is required on some platforms -
* otherwise further access to the R G B channels in the
* LP5521_REG_ENABLE register will not have any effect - strange!
*/
lp5521_read(client, LP5521_REG_R_CURRENT, &buf);
if (buf != LP5521_REG_R_CURR_DEFAULT) {
dev_err(&client->dev, "error in reseting chip\n");
goto fail2;
}
usleep_range(10000, 20000);
ret = lp5521_detect(client);
if (ret) {
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment