Commit 18bfc8fa authored by Aditya Prayoga's avatar Aditya Prayoga Committed by Joe Hershberger

net: mvneta: Add GPIO configuration support

This patch add GPIO configuration support in mvneta driver.
Driver will handle PHY reset. GPIO pins should be set in device tree.

Ported from mvpp2x
[https://patchwork.ozlabs.org/patch/799654/]

Initial discussion to port the changes into mvneta
[https://patchwork.ozlabs.org/patch/1005765/]
Signed-off-by: default avatarAditya Prayoga <aditya@kobol.io>
Tested-by: default avatarDennis Gilmore <dgilmore@redhat.com>
Reviewed-by: Stefan Roese's avatarStefan Roese <sr@denx.de>
Acked-by: Joe Hershberger's avatarJoe Hershberger <joe.hershberger@ni.com>
parent 92f129f4
......@@ -27,6 +27,7 @@
#include <asm/arch/soc.h>
#include <linux/compat.h>
#include <linux/mbus.h>
#include <asm-generic/gpio.h>
DECLARE_GLOBAL_DATA_PTR;
......@@ -274,6 +275,9 @@ struct mvneta_port {
int init;
int phyaddr;
struct phy_device *phydev;
#ifdef CONFIG_DM_GPIO
struct gpio_desc phy_reset_gpio;
#endif
struct mii_dev *bus;
};
......@@ -1749,6 +1753,17 @@ static int mvneta_probe(struct udevice *dev)
if (ret)
return ret;
#ifdef CONFIG_DM_GPIO
gpio_request_by_name(dev, "phy-reset-gpios", 0,
&pp->phy_reset_gpio, GPIOD_IS_OUT);
if (dm_gpio_is_valid(&pp->phy_reset_gpio)) {
dm_gpio_set_value(&pp->phy_reset_gpio, 1);
mdelay(10);
dm_gpio_set_value(&pp->phy_reset_gpio, 0);
}
#endif
return board_network_enable(bus);
}
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment