Commit 2bd3cab3 authored by Chris Packham's avatar Chris Packham Committed by Tom Rini

rtc: ds1337: drop "SYS" from config variables

There is some inconsistency between uses of CONFIG_RTC_DS13xx and
CONFIG_SYS_RTC_DS13xx. Address this by dropping the "SYS" from
these variables.
Signed-off-by: default avatarChris Packham <judge.packham@gmail.com>
Reviewed-by: Simon Glass's avatarSimon Glass <sjg@chromium.org>
parent 1a73bd84
......@@ -1015,7 +1015,7 @@ The following options need to be configured:
CONFIG_RTC_DS164x - use Dallas DS164x RTC
CONFIG_RTC_ISL1208 - use Intersil ISL1208 RTC
CONFIG_RTC_MAX6900 - use Maxim, Inc. MAX6900 RTC
CONFIG_SYS_RTC_DS1337_NOOSC - Turn off the OSC output for DS1337
CONFIG_RTC_DS1337_NOOSC - Turn off the OSC output for DS1337
CONFIG_SYS_RV3029_TCR - enable trickle charger on
RV3029 RTC.
......
......@@ -150,11 +150,11 @@ int rtc_set (struct rtc_time *tmp)
* SQW/INTB* pin and program it for 32,768 Hz output. Note that
* according to the datasheet, turning on the square wave output
* increases the current drain on the backup battery from about
* 600 nA to 2uA. Define CONFIG_SYS_RTC_DS1337_NOOSC if you wish to turn
* 600 nA to 2uA. Define CONFIG_RTC_DS1337_NOOSC if you wish to turn
* off the OSC output.
*/
#ifdef CONFIG_SYS_RTC_DS1337_NOOSC
#ifdef CONFIG_RTC_DS1337_NOOSC
#define RTC_DS1337_RESET_VAL \
(RTC_CTL_BIT_INTCN | RTC_CTL_BIT_RS1 | RTC_CTL_BIT_RS2)
#else
......@@ -162,16 +162,16 @@ int rtc_set (struct rtc_time *tmp)
#endif
void rtc_reset (void)
{
#ifdef CONFIG_SYS_RTC_DS1337
#ifdef CONFIG_RTC_DS1337
rtc_write (RTC_CTL_REG_ADDR, RTC_DS1337_RESET_VAL);
#elif defined CONFIG_SYS_RTC_DS1388
#elif defined CONFIG_RTC_DS1388
rtc_write(RTC_CTL_REG_ADDR, 0x0); /* hw default */
#endif
#ifdef CONFIG_SYS_DS1339_TCR_VAL
rtc_write (RTC_TC_REG_ADDR, CONFIG_SYS_DS1339_TCR_VAL);
#ifdef CONFIG_RTC_DS1339_TCR_VAL
rtc_write (RTC_TC_REG_ADDR, CONFIG_RTC_DS1339_TCR_VAL);
#endif
#ifdef CONFIG_SYS_DS1388_TCR_VAL
rtc_write(RTC_TC_REG_ADDR, CONFIG_SYS_DS1388_TCR_VAL);
#ifdef CONFIG_RTC_DS1388_TCR_VAL
rtc_write(RTC_TC_REG_ADDR, CONFIG_RTC_DS1388_TCR_VAL);
#endif
}
......
......@@ -311,7 +311,7 @@
#define CONFIG_SYS_SPD_BUS_NUM 1 /* For rom_loc and flash bank */
#define CONFIG_RTC_DS1337
#define CONFIG_SYS_RTC_DS1337_NOOSC
#define CONFIG_RTC_DS1337_NOOSC
#define CONFIG_SYS_I2C_RTC_ADDR 0x68
#define CONFIG_SYS_I2C_PCA9557_ADDR 0x18
#define CONFIG_SYS_I2C_NCT72_ADDR 0x4C
......
......@@ -29,7 +29,7 @@
#define CONFIG_SYS_RTC_BUS_NUM 2
#define CONFIG_SYS_I2C_RTC_ADDR 0x68
/* Turn off RTC square-wave output to save battery */
#define CONFIG_SYS_RTC_DS1337_NOOSC
#define CONFIG_RTC_DS1337_NOOSC
/* LED */
......
......@@ -2264,9 +2264,12 @@ CONFIG_RSK7264
CONFIG_RSK7269
CONFIG_RTC_DS1307
CONFIG_RTC_DS1337
CONFIG_RTC_DS1337_NOOSC
CONFIG_RTC_DS1338
CONFIG_RTC_DS1339_TCR_VAL
CONFIG_RTC_DS1374
CONFIG_RTC_DS1388
CONFIG_RTC_DS1388_TCR_VAL
CONFIG_RTC_DS1556
CONFIG_RTC_DS174x
CONFIG_RTC_DS3231
......@@ -3369,8 +3372,6 @@ CONFIG_SYS_DRAMSZ1
CONFIG_SYS_DRAM_BASE
CONFIG_SYS_DRAM_SIZE
CONFIG_SYS_DRAM_TEST
CONFIG_SYS_DS1339_TCR_VAL
CONFIG_SYS_DS1388_TCR_VAL
CONFIG_SYS_DSPIC_TEST_ADDR
CONFIG_SYS_DSPIC_TEST_MASK
CONFIG_SYS_DSPI_CS0
......@@ -5501,9 +5502,6 @@ CONFIG_SYS_RSTC_RMR_VAL
CONFIG_SYS_RTCSC
CONFIG_SYS_RTC_BUS_NUM
CONFIG_SYS_RTC_CNT
CONFIG_SYS_RTC_DS1337
CONFIG_SYS_RTC_DS1337_NOOSC
CONFIG_SYS_RTC_DS1388
CONFIG_SYS_RTC_OSCILLATOR
CONFIG_SYS_RTC_PL031_BASE
CONFIG_SYS_RTC_REG_BASE_ADDR
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment