• Russell King - ARM Linux's avatar
    ARM: dts: Fix OMAP4430 SDP Ethernet startup · 54b53c59
    Russell King - ARM Linux authored
    [ Upstream commit 84fb6c7feb1494ebb7d1ec8b95cfb7ada0264465 ]
    
    It was noticed that unbinding and rebinding the KSZ8851 ethernet
    resulted in the driver reporting "failed to read device ID" at probe.
    Probing the reset line with a 'scope while repeatedly attempting to
    bind the driver in a shell loop revealed that the KSZ8851 RSTN pin is
    constantly held at zero, meaning the device is held in reset, and
    does not respond on the SPI bus.
    
    Experimentation with the startup delay on the regulator set to 50ms
    shows that the reset is positively released after 20ms.
    
    Schematics for this board are not available, and the traces are buried
    in the inner layers of the board which makes tracing where the RSTN pin
    extremely difficult.  We can only guess that the RSTN pin is wired to a
    reset generator chip driven off the ethernet supply, which fits the
    observed behaviour.
    
    Include this delay in the regulator startup delay - effectively
    treating the reset as a "supply stable" indicator.
    
    This can not be modelled as a delay in the KSZ8851 driver since the
    reset generation is board specific - if the RSTN pin had been wired to
    a GPIO, reset could be released earlier via the already provided support
    in the KSZ8851 driver.
    
    This also got confirmed by Peter Ujfalusi <peter.ujfalusi@ti.com> based
    on Blaze schematics that should be very close to SDP4430:
    
    TPS22902YFPR is used as the regulator switch (gpio48 controlled):
    Convert arm boot_lock to raw The VOUT is routed to TPS3808G01DBV.
    (SCH Note: Threshold set at 90%. Vsense: 0.405V).
    
    According to the TPS3808 data sheet the RESET delay time when Ct is
    open (this is the case in the schema): MIN/TYP/MAX: 12/20/28 ms.
    Signed-off-by: 's avatarRussell King <rmk+kernel@armlinux.org.uk>
    Reviewed-by: 's avatarPeter Ujfalusi <peter.ujfalusi@ti.com>
    [tony@atomide.com: updated with notes from schematics from Peter]
    Signed-off-by: 's avatarTony Lindgren <tony@atomide.com>
    Signed-off-by: 's avatarSasha Levin <sashal@kernel.org>
    54b53c59
omap4-sdp.dts 15.4 KB